Cooper TS690 Manual de instalación descargar pdf (Pagina 38)

34 Entry Keypad Lock

When programmed as “Yes” then users cannot

unset the system from a keypad during entry.

Program this option as “Yes” if you are installing

a DD243:2002 compliant system and the user

must unset the system with a proximity

detector (“Portable ACE”). The user must

employ a proximity tag to disarm the system

during the entry period.

When programmed as “No” then users can

unset the system from a keypad during entry.

If your make Pset Com. Dly (Eng 1.5.03) =

199 then users can unset the system from

a keypad when the system is part-set.

(Default = No)

35 Tamp as Burg

DD243: 2002 states that alarm signals and

confirmation signals must be transmitted using

certain codes. In some case these codes do

not conform to Cooper Security Ltd’s

implementation of the CID standard. This

option allows you to program the control unit to

send tampers as alarm.

When programmed as “Yes” then the control

unit sends tampers to the ARC as Intruder

Alarm (CID 130). In Fast Format the control unit

transfers the Digicom Tamper output (default

output 8) to the Digicom Alarm output (default

output 3).

When programmed as “No” the control unit

sends all messages as specified in Report

Mode.

(Default = No)

36 Entry Confirmation After 2 circuits

When programmed as “Yes” the control unit

sends a confirmed alarm if an intruder

activates two separate zones after the entry

timer expires. If the control unit is in alarm

before the user starts entry then only one

subsequent zone violation is required.

Note: Select this option if you are installing a

DD243:2002 para 6.4.5 compliant system and

the user must unset the system with a proximity

detector (“Portable ACE”).

Whe programmed as “No” the control unit

sends a confirmed alarm if the intruder

activates one zone after the entry timer

expires. This option does not comply with

DD243:2002.

If you program Confirmation After Entry

as “No” then the setting of this option has

no effect.

37 Unconf Usr Rst

When programmed as “Yes” then users can

reset the system after an unconfirmed alarm.

When programmed as “No” then an engineer

or the ARC must reset the system after an

unconfirmed alarm.

(Default = “Yes”)

38 Keypad PA On

When programmed as “Yes” then the user can

start a PA alarm by pressing keys 1 and 3 at the

same time. Program as “No” to remove this

option.

(Default = “No”.)

38

Engineer’s Menu 1 TS690 & TS690ID Installation Manual

Configuration

Enter Number >--

User reset

Option 07 - Yes

User reset

Option 07 - No

to alternate Yes and No

Option No.

9

B

ENT

Enter configuration No.

e.g.07foruserreset

ENT

Engineers menu 1

Select Options :-

StarburstLCD

LED

E1 -

ENGR 1 -

co.--

CONFIG.--

YES

YES

NO

NO

Configuration Flowchart

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Comentarios a estos manuales

Sin comentarios