Cooper TS690 Manual de instalación descargar pdf (Pagina 14)

5. Set the “ENT KEY DISABLE” jumper link to the

required position.

6. Set the “WARD SOUNDER CONTROL” jumper link

to the required position.

7. Finally clip the remote keypad cover onto the

base being careful not to trap any cables or to

obstruct the tamper switch.

Keypad Loudspeaker Connections

A single 16 Ohm loudspeaker may be wired to the

keypad if required. This loudspeaker will follow the

existing keypad sounder and its volume level can

be adjusted by the speaker volume pot (VR1).

The speaker output and volume pot are

only available on the NETLCD keypad.

Engineer’s Keypad

Normally all system programming will be carried

out from one of the installed remote keypads,

however sometimes it may be more convenient

to program the system at the control panel. This

can be achieved by using an “Engineers Keypad”

which is temporarily plugged on to the control

panel (JP2). To convert a standard remote keypad

to an “Engineers Keypad” an Engineer’s interface

lead is required which can be obtained from your

supplier (P/No. NETEKI).

TS700 LEC Installation

The TS700 LEC (Local Expansion Card) is

connected to the “Remote Network” and provides

two additional programmable detection circuits

and a programmable output. The “Remote

Network” may have up to three LECs connected,

as the system will always require at least one

remote keypad.

Always ensure that all power (mains and

battery) is removed before making any

connections to the LEC..

1. Remove the cover from the base and carefully

remove the PCB.

2. If the LEC is being fitted inside the control panel

you may remove the LEC PCB from its base

and secure it to base of the control panel using

self adhesive feet. If required, the tamper

switch may also be disabled by fitting the

jumper link across JP2, see Figure 10.

3. If the LEC is being fitted outside the control

panel, hold the base in position and mark the

two securing holes. Drill and plug the wall, then

pass all cables into the base via the cable

entry points. Secure the base to the wall using

the appropriate fixing screws.

14

System Installation TS690 & TS690ID Installation Manual

1x16Ohm

Loudspeaker

ABCDE

SPK

+

O/P

-

Figure 9. NETLCD Speaker Connections

Control Panel

To TS900

Remote

Keypad

A (Red)

A

AUX

12V

0V

ENGINEERS REMOTE

JP2

C (Yellow)

B

B(Black)

C

D(White)

D

E(Blue)

E

7 Way 0.1" Molex

connector

Figure 10. Engineer’s Keypad Connection

Network

connections

Programmable

output

switched -ve

@100mA

Tamper switch

Fit jumper-link to

disable tamper switch

CABLE ENTRY

CABLE ENTRY

Programmable

detection circuits

I/D selector

CCT B

ED

C

B

LEC I/D

A

12 34

NULL

JP2

TAMPER = JP2 NOT FITTED

NO TAMPER = JP2 FITTED

CCT A

TA

TB

ZA

ZB

O/P

Figure 11. TS700.LEC Layout

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Comentarios a estos manuales

Sin comentarios