Cooper TS690 Manual de instalación Pagina 19
- Pagina / 60
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Application
The DC6 digital communicator/modem is suitable
for connection to the following types of telephone
line:
l
Direct exchange lines (PSTN) supporting DTMF
(Tone dialling) or Loop Disconnect (Pulse
Dialling).
l
PABX exchanges (with or without secondary
proceed indication).
The DC6 is only approved for use with
compatible PABXs. Correct operation in all
circumstances is not guaranteed.
The DC6 is fully compatible with BT Network
services.
Only control panels fitted with V2.0 or later
software, or DC6’s fitted with V1.17 or later
software are compatible with Call Minder
and Call Divert services. For full details on
compatibility refer to Technical Bulletin
002/04/98 or contact Technical Support.
Approval
The DC6 digital communicator/modem is not
suitable for connection as an extension to a pay
phone or 1+1 carrier systems. The DC6 digital
communicator/modem is approved for the
following usage:
l
Automatic call initialisation
l
Operation in absence of proceed indication
l
Multiple repeat attempts
l
Modem
Usage other than the approved usage or failure to
comply with the installation and programming
instructions may invalidate any approval given to
the apparatus.
Connections
Connection terminals on the DC6 are described
as "Telecommunications Network Voltage" circuits
(TNV).
It is important that the installer ensures that
TNV connections are only connected to
the PSTN and SELV circuits are only
connected to other circuits designated as
SELV circuits.
Please ensure that cabling to the
telephone line connections (TNV) are
routed well away from the detection
circuitry (SELV) and the cabling to the
detection circuitry (SELV) are routed well
away from the telephone circuitry (TNV).
Interconnection circuits should be such
that the equipment continues to comply
with the requirements of 4.2 of EN 41003 for
TNV circuits and 2.3 of EN 60950 for SELV
circuits, after making connections
between circuits.
19
TS690 & TS690ID Installation Manual System Installation
Telephone cable
Type 1/0.5mm CW130
8
A = 5 - White/Blue ring
B = 2 - Blue/White ring
NOTE
The A1 and B1 telephone connections are not
used on the UK version of the DC6.
6
5
4
ABB1A1
Status
LED
Plug onto
JP4
Telephone Line
Connections
(TNV)
Mounting Pilar
Holes
Mounting Pilar
Holes
3
2
1
Figure 22. DC6 Connections
- TS690 & TS690ID 1
- Overview 2
- System Installation 2
- Engineer’s Menu 1 2
- Engineer's Menu 2 3
- Appendices 3
- Number of Zones = 8 to 14 5
- Number of Zones = 2 to 38 5
- Supply: 230V ±10% 50Hz 6
- ID Loop Wiring (TS690ID Only) 8
- Cabling Requirements 8
- Control Panel Installation 9
- Control Panel PCB Layout 10
- FUSE 315mA 12
- Installation Procedure 13
- Engineer’s Keypad 14
- TS700 LEC Installation 14
- Wiring Detection Circuits 15
- Double Pole 15
- End Of Line 15
- Wiring ID Biscuits 16
- Biscuit Connections 16
- Wiring A Biscuit to a PIR 16
- External Sounder Connections 17
- Auxiliary Tamper 17
- Extension Loudspeakers 18
- Digicom/RedCARE Installation 18
- DC6 Digi-Modem Installation 18
- Regulatory Requirements 18
- Application 19
- Approval 19
- Connections 19
- Installation 20
- DC54 & DC58M Installation 20
- DATAC or RS232 printer 21
- CPA6 Printer 21
- RS232 Data 21
- Pre Power-Up Checks 22
- Initial Power-Up 23
- Power-Up Checks 23
- NVM Defaults 24
- Panel Outputs [1.1] 26
- Digicom Outputs [1.2] 26
- Digicom Channels [1.3] 26
- Programmable Output Types 26
- No Type/Description 27
- Program Circuits [1.4] 29
- Circuit Types 29
- Circuit Attributes 30
- System Timers [1.5] 31
- Setting Modes [1.6] 33
- Do System Print [1.7] 34
- Remote Reset Algorithm [1.8] 35
- Configuration [1.9] 35
- 34 Entry Keypad Lock 38
- 35 Tamp as Burg 38
- 37 Unconf Usr Rst 38
- 38 Keypad PA On 38
- RESET 1.9V to 2.4V 39
- MID 5.6 to 6.4V 39
- HIGH 9.0 to 10.1V 39
- Relearn Hardware [1.C] 40
- StarburstLCD 42
- Change Passcode [2.4] 43
- Chime Circuits [2.5] 43
- Alter Shunt Group [2.6] 43
- Print System Log [2.7] 43
- Configure Part Sets [2.8] 44
- View System Log [2.9] 44
- Log Event Codes 45
- Reset User Code 1 [2.0] 46
- Start Call Back [2.A] 46
- LCD Only 47
- Modem Password 48
- Modem Site No 48
- Program Digicom 48
- Text Editing Keys 50
- Cursor Types 50
- Common Key Sequences 50
- TS690/TS690ID 53
- Setup New Users Flowchart 54
- Engineers Menu 1 55
- Engineers Menu 2 56
- Output Types 56
- Quick Reference User Menus 57
- User Menu 1 57
- User Menu 2 57
- 496804 Issue 1 60
Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper TS690
(432 paginas)
(110 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.035 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales