Cooper TS690 Manual de instalación descargar pdf (Pagina 28)

No Type/Description

032 Duress Alarm

Activates when a duress passcode is entered

and deactivates when the duress alarm is

reset.

033 System Part Set

Activates when the system is part set and

deactivates when the system is fully set or

unset.

034 Battery Fault

Activates when a battery fault occurs and

deactivates when the battery fault is cleared.

035 Set Fail

Activates when the system fails to set and

deactivates when the set fail condition is reset

by the user.

036 System Open

Activates when the system is unset,,

deactivates when the system is fully set or

part-set.

037 New Alarm

Activates for 2 seconds when any circuit

causes a new alarm condition.

038 24hr Circuits Omitted

Activates when one or more 24 Hour circuits

are omitted.

039 Modem Lockout

Activates when the modem is locked-out (four

failed attempts). Deactivates when a master

user passcode is entered or after 4 hours.

040 Chime Mimic

Activates for 2 seconds when a circuit that is

programmed as "chime" is activated.

041 Shunt Group Active

Activates when the shunt code has been used

to shunt a group of circuits. Deactivates when

the shunt code is used again to re-instate the

circuits.

042 Timed Output

Activates when a "Monitored" circuit is

triggered and remains active for the duration

of the "Monitor Delay" see System Timers.

043 Abort

Activates for 5 seconds after an alarm is

aborted by the user. The period in which the

alarm may be aborted is set by the "Abort

Delay" see System Timers.

No Type/Description

044 General Fault

Activates during battery fault or when the

system is prevented from being set.

Deactivates when all faults are cleared.

045 Battery Test

Activates for 1 minute on the hour every hour.

This output is used to test the battery in remote

PSU’s using a 519FM monitor PCB).

046 Service Call

Activates when the system is on-line with a

remote PC and Lineload software.

047 System Full Set

Activates when all areas within the system are

set and deactivates when any area is unset.

048 Strobe on Set

Activates when there is an alarm, and

deactivates when the alarm is cancelled by

the user. This output is also active for 10

seconds after a user sets the system with full

alarm response.

049 Service Call

The contral panel activates this output when it

requires a service call. The control panel

deactivates the output when an engineer

enters programming mode.

050 PC Output 1

This output type is switched on and off via the

PC and Lineload software.

051 PC Output 2

This output type is switched on and off via the

PC and Lineload software.

052 Sounder Control

Normally used as the 0V connection for an

extension loudspeaker so that only system

alarm tones are generated. Only suitable for

Panel Outputs 1 and 2.

053 ID Loop Shorted

The control panel activates this output if

something shorts the ID loop.

054 Call Engineer

Activates when the system requires an

"Engineer Reset", deactivates when the

system is reset by the engineer or "Remote

Reset".

055 Always Off

Never activates.

056 Active Omit

If an event triggers a latching circuit type (for

example a door or break glass, but NOT a PIR),

28

Engineer’s Menu 1 TS690 & TS690ID Installation Manual

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Comentarios a estos manuales

Sin comentarios