Cooper DF6000 Manual de usuario descargar pdf (Pagina 103)

DF6000 - USER MANUAL

103

Detector Base Wiring - MAB800

Supply Voltage 18 - 30 V dc

Cable Size 0.5 - 2.5mm²

Recommended cable types FIRETUF,FP200 or MICC

Mounting hole centres 50 - 80mm

Wiring Hints

1. Each terminal is suitable for clamping up to 2 wires

2. Clamping of 2 wires of very different diameters under one screw is not recommended.

3. Suitable for mounting to mounting boxes with 50-80mm ﬁxing centres. General If difﬁculty is

experienced when mounting the detector, this may be due to the following:

4. Wiring causing an obstruction - move or shorten wires.

5. Although the base is tolerant to uneven mounting surfaces, a very uneven surface may cause the base

to deform when the mounting screws are tightened down - loosen screws to reduce this or slide base

to a more ﬂat position.

WARNING: Do not use high voltage testers when detectors or control panel are connected to the

system.

Section 5 - Appendix

+VIN

- VE COM OUT

earth screen of cable to be continuous between detectors

- VE COM IN

Attention: If using the outer connection on terminal 2, ensure the operation of the switch

is not impeded and that there no shorts between terminal 2 and the switch contact.

Ensure that the cable does not short onto the contact

Analogue addressable

ﬁre alarm panel

Loop start

Loop ﬁnish

S+

S-

F-

F+

remote indicator

LED (optional)

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 113 114

Sin comentarios

Cooper DF6000 Manual de usuario Pagina 103