Cooper 9448ES Manual de servicio descargar pdf (Pagina 6)

6 496574

user sets the system by keying "2 + R + ACCESS CODE". (You cannot

program the system to omit Entry/Exit zones.) This facility can be used, for

example, to protect a downstairs floor while the family is sleeping upstairs.

The part set system may need a separate Entry/Exit Zone from the full set

system. In the example, family members will enter the protected area by the

stairs rather than by the front door.

The Installer can program zone 1 to be an Entry/Exit Zone while the system

is part set. Once programmed, opening zone 1 when the system is part set

starts the entry timer. Note that zone 1 behaves as an Entry Route when the

system is full set.

The Installer can also program the system for Silent Part Set. Once pro-

grammed, the control panel does not give any tones during the exit time.

The Installer can program the alarm response during part set to be either Full

(internal and external sounders, and trigger Intruder communications output

pin) or Internal Sounder Only (no external sounders, do not trigger Intruder

output pin). See "Communication Outputs" overleaf for a description of the

communicator output pins.

Entry and Unsetting the System

Opening the Entry/Exit Zone when the panel is set starts the entry timer, and

the panel gives an entry tone. The panel can be programmed with one of five

delays to allow the user to get in and unset the panel.

If the entry time elapses before the end user enters the access code, the

panel starts a fixed 30 second Dual Ply timer and gives an internal alarm.

The user must enter a valid access code before the Dual Ply timer runs out

or the panel starts a full alarm. The Installer can disable the Dual Ply timer in

programming. The panel then gives a full alarm at the end of the entry time.

Normally Zone 1 is an Entry Route zone; it is ignored during the entry/exit

time. If necessary the Installer can program zone 2 as an additional Entry

Route. If the user strays from the Entry Route then the panel starts the Dual

Ply timer and gives an internal alarm. If the user does not enter the access

code before the Dual Ply timer ends then the panel gives a full alarm. If the

Installer disables the Dual Ply timer then the panel starts a full alarm as soon

as the user strays from the Entry Route.

Alarm

External and Internal Sounders

The panel provides two separate transistorised outputs to control an Exter-

nal Sounder and Strobe. The external sounder and strobe usually com-

prises a bell or siren fitted in a tamper proof housing with the strobe warning

light fitted to the casing. A control module fitted within the casing contains a

1. Introduction

1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Sin comentarios

Cooper 9448ES Manual de servicio Pagina 6