Cooper 9448ES Manual de servicio descargar pdf (Pagina 5)

496574 5

1. Introduction

C Used to enable or disable the Chime facility.

l Used to read the 10-event log. When reading the log, press-

ing << (1) displays earlier events, and >> (3) displays later

events.

System Features

Detectors

The panel provides connections for up to six separate detector zones. Each

zone is a closed circuit loop that can be connected to door contacts or

Passive Infra Red (PIR) detectors. Whe the system leaves the factory all

zones are programmed as Normal Alarm zones. If no device is connected to

a zone, the Installer must program it as Not Used (see "4. Programming").

Zone 5 can be programmed as a Fire zone. When this zone is triggered the

system will give a distinctive two-tone fire alarm. Zone 6 can be programmed

as a Panic Alarm. A Panic Alarm will start a full alarm whether the system is

set or unset.

The panel provides a separate Entry/Exit Zone for a door contact or PIR on

the entrance door. Zone 3 can be programmed as an additional Entry/Exit

zone if required.

All wiring, detectors, bell circuits and the panel lid are protected by an Anti

Tamper loop. If the anti-tamper loop is broken then the panel gives an

audible warning from the internal sounder and lights the Tamper LED if the

panel is unset, or a full alarm if the panel is set.

To power detectors (and other devices) the panel provides a 12 volt positive

and negative Auxiliary Power Output.

Full Setting

To full set the system the user enters a four digit access code. When the

code is complete the panel gives an exit tone and starts the exit timer.

If any zone is open during the exit time then the control panel gives an

interrupted tone. The panel gives an alarm tone from the internal speakers if

the zone remains open at the end of the exit time.

Exit Times

The panel can be programmed with one of five exit delays to allow the user to

leave during setting. The exit delay applies to both full set and part set.

Part Setting

The Installer can program the panel so that certain zones are omitted if the

1 2 3 4 5 6 7 8 9 10 ... 59 60

Sin comentarios

Cooper 9448ES Manual de servicio Pagina 5