Cooper 9448ES Manual de servicio descargar pdf (Pagina 14)

14 496574

3. INSTALLATION

Installing the alarm system comprises the following steps:

1. Run cables from the position of the detectors, any remote keypad, and

external sounders to the control panel position.

2. Fit the control panel, detectors, remote keypad, and external sounders

in their chosen locations.

3. Connect the mains cable with power OFF and fit the standby battery (do

not connect the battery at this stage).

4. Connect the remote keypads (if fitted).

5. Connect the detectors (but NOT to the 12V AUX supply at this point).

6. Connect the external sounder. Do not complete the connection to the

12V terminal on the lower connector at this stage.

7. Apply power (battery and mains) for the first time.

8. Connect the external sounder to the 12V terminal on the lower connec-

tor and the detectors to the 12V AUX terminal.

9. Program the system (see "4. Programming").

10. Hand over to the user.

Fitting the System

Fitting the Control Panel

(a) Remove the control panel from the packing.

(b) Remove the front screw and open the hinged lid to the left. Note the

slotted central keyway located at the top of the back box.

Now mark the remaining holes, remove the panel and continue to drill

the other two holes.

(d) Refit the panel to the wall using not less than 30mm x No 8 Dome or

Pan-head screws.

Note: Do not drill the holes with the panel in position as this may result in damage to

the electronics.

Fitting a Remote 9427 Keypad

Figure 6 shows the 9427 keypad.

1. Unclip the keypad faceplate and remove it from the back of the case.

2. Hold the keypad back in place and mark, drill and plug the position of

one fixing hole.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Sin comentarios

Cooper 9448ES Manual de servicio Pagina 14