Cooper M3000 Guía de usuario descargar pdf (Pagina 376)

A-2 SPARC Enterprise Mx000 Servers XSCF User’s Guide • December 2010

■ Panic message

This message is output in case of panic. The panic message is output to the domain console

and retained as log information in the XSCF. The panic log retains the information

corresponding to the last single panic event that occurred. The showlogs(8) command of

XSCF can be used to display the panic log.

■ Console message

The console message is a general term used to describe syslog messages, FMA messages,

panic messages, IPL messages, and other messages output by POST, OpenBoot PROM, and

the Oracle Solaris OS. The console messages are output to each domain console and are

retained as log information (in a console log) in the XSCF. The showlogs(8) command of

the XSCF Shell can be used to display the console log.

Note – Console messages are overwritten, beginning with the oldest message. Even when

the wraparound feature causes a console message to be overwritten, the system startup

message is retained in the IPL log, and in case of panic, the log is retained in the panic log.

When the XSCF unit is redundant, the console messages retained in the XSCF Unit on the

active side are not copied to the standby side. Accordingly, after the XSCF Unit is switched,

the console messages on the previously active side cannot be referenced.

■ Monitoring message

The XSCF firmware outputs this message to notify the server fault or status. The monitoring

message is output by using the showmonitorlog(8) command, and retained as log

information (in a monitor message log or XSCF error log) in the XSCF. The showlogs(8)

command of the XSCF Shell can be used to display the monitoring message and XSCF error

log for more detailed investigation. Authorized service personnel use the DIAGCODE output

in the message to acquire detailed information.

Note – Monitoring messages are overwritten, beginning with the oldest message. When the

XSCF Unit is redundant, monitoring messages output by the XSCF Unit on the active side

are also managed on the standby side. Even after the XSCF Unit is switched, the monitoring

messages on the previously active side can be referenced.

■ Other notice message

In addition to the messages above, there is a notification message displayed on the domain

console when power off or reset processing is performed normally or an event occurs.

1 2 ... 371 372 373 374 375 376 377 378 379 380 381 ... 431 432

Sin comentarios

Cooper M3000 Guía de usuario Pagina 376