Cooper 9448 Manual de usuario descargar pdf (Pagina 8)

8 of 12 496328 Issue 2

Changing Default Programming

To change the factory defaults, the panel must be in programming mode.

Then:

1. Key in a two digit programming command followed by "ENTER". (See

"Engineer Program Command List".)

On commands 35 to 68 a LED will glow to show you the current option

used in the command. If the LED is OFF the option is "0".

2. Key in the correct digit for the option you want, and then press ENTER.

The panel beeps twice to show that it has accepted the command. All

the LEDs flash, and the panel is ready for the next command.

The panel gives a single error tone if you enter an incorrect command.

Re-enter the correct command.

3. Key in "99 ENTER" to leave programming mode when you have fin-

ished. You will then be in user mode.

Engineer Program Command List

To change: Key-in: followed by: Notes Defaults

Zones omitted in 10 ENTER zone n..n ENTER LEDs ON for zones none

Part Set* omitted (see note 1)

Chime 11 ENTER zone n..n ENTER LEDs ON for chime none

(EE zone = zone 7)

Zones Not Used 15 ENTER zone n..n ENTER LEDs OFF for zone none

not used (see note 2)

Engineer Code 20 ENTER new code ENTER 4 digits 7890

User Code 1 21 ENTER new code ENTER 4 digits (see note 3) 1234

User Code 2 22 ENTER new code ENTER 4 digits (see notes 3 & 4) 0000

Silent Part set 35 ENTER 0 ENTER Audible

1 ENTER Silent y

Zone 2 Entry 36 ENTER 0 ENTER Normal Alarm y

Route 1 ENTER Entry Route

Auto Re-Arm 40 ENTER 1 ENTER Never rearm y

2 ENTER Rearm once

3 ENTER Rearm twice

4 ENTER Rearm three times

Bell Time 42 ENTER 1 ENTER 90 seconds

2 ENTER 3 minutes

3 ENTER 10 minutes

4 ENTER 20 minutes y

To change: Key-in: followed by: Notes Defaults

Changing Default Programming 9448+/9448ES

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Cooper 9448 Manual de usuario Pagina 8