Cooper 9448 Manual de usuario descargar pdf (Pagina 11)

496328 Issue 2 11 of 12

Engineer Walk Test

Allows the engineer to test all devices on the system.

1. Enter programming mode.

2. Key in "97 ENTER".

The panel gives a continuous tone.

3. Open and close each detector contact in turn.

When a detector contact is open the panel gives an interrupted tone and

flashes the zone LED.

4. Press OMIT to stop the walk test.

Note that the Engineer's walk test allows you to test all zones including PA

zones, zone tampers, and panel and bell tampers. The user's walk test does

not allow this.

User Commands

Set/Unset System User code

Part Set 2 + ENTER + User code

Omit zone Zone number + Omit (repeat for all zones to be

omitted) + User code

Keypad PA 1 + 3

Test Bells 4 + ENTER + User code

Walk Test 5 + ENTER User code

Omit to end test

Change User code 6 + current user code

Current user code again

New user code.

Chime On/Off 7 + ENTER + User code

Read Log 8 + ENTER +User code

<< for earlier events

>> for later events

9448+/9448ES Engineer Walk Test

1 2 ... 6 7 8 9 10 11 12

Sin comentarios

Cooper 9448 Manual de usuario Pagina 11