Cooper Menvier 100 Información técnica descargar pdf (Pagina 20)

Code Description

UMPS-100 Pull Station, SPST Single Action, Terminals, Key Reset

+ULMCIM-C

UMPS-400X Pull Station, Explosion Proof, Single Action, Key Reset

+ULMCIM-C

UMPS-100WP Pull Station, SPST Single Action, Terminals, Key Reset

+ULMCIM-C

UMPS-200 Pull Station, SPST Double Action, Terminals, Key Reset

+ULMCIM-C

Product Codes

Installation

The Series MPS Pull Station may be surface mounted

indoors with a separately ordered backbox option or

flush mounted on a standard single gang switch

plate. In either case be sure to follow local codes and

regulations. To comply with ADA standards the Pull

Station must be less than 48 inches above the floor

for front wheelchair access, and less than 54 inches

above the floor for side wheelchair access. MPS Pull

Stations, when mounted to the Series MPS-WP

Backbox with Gasket Assembly, are listed for outdoor

use and are NEMA-3R listed.

Surface Mount

A surface mount installation uses a red diecast

(MPS-WB) or sheet metal (MPS-ISB) Backbox. The

backbox has four pre-drilled mounting holes of

0.187-inch diameter. A screw size of 8 or smaller can

be used to attach the backbox to a wall. After the

backbox is in place, attach the conduit. The diecast

backbox (MPS-WB) has an opening that is tapped for

a 1/2 inch NPT fitting which may be oriented at the

top or bottom when the box is attached to the wall.

The sheet metal backbox (MPS-ISB) has conduit

knockouts. Field wiring is connected to a terminal

block as shown in the wiring drawings. The wiring

should not be wrapped around the terminal, but

placed under the clamping plate. The housing is

locked using a keylock. Unlock the housing by

turning the key clockwise and swing down the front

of the housing to make the sheet metal mounting

plate accessible. Mount the metal plate to the

backbox using the four 1/4 inch length, 8-32 screws

that are supplied. If a Breakrod (MPS-RODS) is being

used, move the PULL handle to about a 45-degree

angle with the face of the housing. Insert a breakrod

into the cavity beneath the PULL handle. Place the

PULL handle back into the normal position (flush with

the housing). While holding the PULL handle in place,

move the housing back to the upright position and

lock. The Pull Station in now ready for operation.

Flush Mount

Most flush mount installations may be attached to a

standard single gang switch box (not supplied) The

only difference between a surface mount installation

and flush mount installation is that the two 6-32

screws are placed through the slots that are centered

on the metal plate.

Standard Connection

Loop In

Loop Out

Addressable

Loop

Power

Limited

Internal

Wiring

Addressable Pull Stations

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Comentarios a estos manuales

Sin comentarios

Cooper Menvier 100 Información técnica Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper Menvier 100