Cooper i-On 40 Manual de usuario descargar pdf (Pagina 5)

S225-40-8

SAFETY

FOR LIFE

5. Connect 115 Vac power to the three-position terminal

block on the right-hand side of the communication

module. Using the White lead supplied, connect the

"N" position to the COM position on the terminal block

next to the RCT. Using the White/Black lead, connect

the "L" position to the 115 position on the terminal

block next to the RCT. See Figures 3 and 4.

6. Connect the provided interface cable to the jack on the

right side of the communications module. See Figure 5.

7. Loosen the module mounting screw next to the RJ-45

port (lower right corner). Place the fork terminal of

the grounding lead from the interface cable between

the brass washer and the communication board and

retighten the screw. See Figure 5.

8. Install the second end of the interface cable to the CL-6

control panel. Mount the control cable fork terminal

lead (grounding lead) to the second threaded hole

adjacent the accessory jacks. See Figure 6. Use the

6-32 x 1/2” screw, #8 Flat washer, and #6 Lock washer

to accomplish this.

S225-40-8

SAFETY

FOR LIFE

N Terminal L Terminal

Figure 3.

Connecting power to module.

Figure 5.

Connecting interface cable to module.

Figure 6.

Connecting interface cable to CL-6 control panel.

Figure 4.

RCT Terminal Block, use to obtain 115 Vac power

source.

Terminal Block

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sin comentarios

Cooper i-On 40 Manual de usuario Pagina 5