Tools and Additional Accessories Required
Standard Screw Driver
Ethernet Communications Module Installation and Operation Instructions
4
INSTALLATION PROCEDURE
TABLE 1
Kit Parts Identification, Kit 57A64328400A
Ethernet Communication Module for CL-6 Controls
Item Description Qty
1 Interface Cable 1
2 Nylon cable clip 1
3 Machine screw, 6-32 x 1/2, round head 2
4 Flat washer, #8, stainless steel 2
5 Cable tie 8
6 Lock washer, #6, stainless steel 2
7 Ethernet/FO Communication Board 1
8 Stand-off stud, 1 1/4" 4
9 Stand-off stud 1/2" 6
10 Machine screw, 10-32 x 3/8", stainless steel 4
11 Lead assembly, #20, white/black 1
12 Lock washer, #10, stainless steel 4
13 Flat washer, #10, brass 4
14 Lead assembly, #20, white 1
15 Reference Drawings 2
Installing Ethernet Card in Cooper
Control Cabinets
Follow these instructions to install the Ethernet
Communications module accessory kits into a CL-6
series control from Cooper Power Systems. The preferred
mounting location is the control box back panel or on the
back of the CL-6B control. For instructions on installing the
module on the back of the control, see the section in this
manual "Installing Ethernet Card in Non-Cooper Control
Cabinets".
1. De-energize the control panel according to the regulator
manufacturers instructions.
On Cooper Power Systems control boxes, open the
V
1
and V
6
(if present) knife switches and close the
C switch on the back panel. This will de-energize
the control panel and also the back panel below the
switches.
2. Locate the four mounting holes on the control back
panel. See Figure 2.
Note: These mounting holes are threaded to accept
the stand-off studs.
3. Screw the 1 ¼” threaded stand-off studs into the
mounting holes on the control box back panel. See
Figure 2.
4. Using the 10-32 x 3/8” screws, brass washers, and
#10 lock washers, mount the communications module
to the stand-off studs. The brass washer is placed
directly on the communications module; the lock
washer is placed between the brass washer and the
screw.
Note: The ST (fiber-optic) connectors should point
down.
Figure 2.
Module mounting location with stand-off studs
mounted, control box back panel.
(12 paginas)
(110 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales