S225-40-8
Introduction
Service Information S225-40-8 provides the installation
and operation instructions for a CL-6 series regulator
control Ethernet communications module.
Read This Manual First
Read and understand the contents of this manual and
follow all locally approved procedures and safety practices
before installing or operating this equipment. Read and
understand the manuals detailing the installation and
operation of the regulator and the regulator control used
with the regulator. Refer to S225-11-1 CL-6 Series Control
Installation, Operation, and Maintenance Instructions
for information on the CL-6 series voltage regulator
control. Refer to S225-10-30 VR-32 Voltage Regulator
with Quik-Drive™ Tap-Changer Installation, Operation, and
Maintenance Instructions for information on the Cooper
Power Systems voltage regulator with Quik-Drive tap-
changer.
Additional Information
These instructions cannot cover all details or variations
in the equipment, procedures, or process described nor
provide directions for meeting every possible contingency
during installation, operation, or maintenance. For additional
information, please contact your Cooper Power Systems
representative.
Acceptance and Initial Inspection
This kit is thoroughly inspected at the factory. It is in good
condition when accepted by the carrier for shipment.
Upon receipt of the regulator kit, a thorough inspection
should be made for damage, evidence of rough handling,
or shortages. Should this initial inspection reveal evidence
of rough handling, damage, or shortages, it should be
noted on the bill of lading and a claim should immediately
be made with the carrier. Also, notify your Cooper Power
Systems representative.
Handling and Storage
Be careful during handing and storage of equipment to
minimize the possibility of damage. If the regulator kit is not
to be placed into immediate use, store the kit where the
possibility of damage is minimized.
Quality Standards
ISO 9001 Certified Quality Management System
Description
The Communications module accessory kit provides
an interface for digital communication using DNP 3.0
protocol. For more information on DNP 3.0 protocol refer
to Reference Information R225-90-10 Data Dictionary
Assignments for Communications Protocol DNP3 for
use with CL-6 Series Regulator Controls and Reference
Information R225-90-11 Device Profile Document for
Communications Protocol DNP3 for use with CL-6 Series
Regulator Control.
S225-40-8
PRODUCT INFORMATION
3
(12 paginas)
(110 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales