Ethernet Communications Module Installation and Operation Instructions
The instructions in this manual are not intended as a
sub stitute for proper training or adequate experience
in the safe operation of the equipment described.
Only competent technicians, who are familiar with this
equipment should install, operate and service it.
A competent technician has these qualifications:
n
Is thoroughly familiar with these instructions.
n
Is trained in industry-accepted high- and low-voltage
safe operating practices and procedures.
n
Is trained and authorized to energize, de-energize, clear,
and ground power distribution equipment.
n
Is trained in the care and use of protective equipment
such as flash clothing, safety glasses, face shield, hard
hat, rubber gloves, clampstick, hotstick, etc.
Following is important safety information. For safe
installation and operation of this equipment, be sure to
read and understand all cautions and warnings.
Safety Instructions
Following are general caution and warning statements that
apply to this equipment. Additional statements, related to
specific tasks and procedures, are located throughout the
manual.
DANGER:
Hazardous voltage. Contact with hazardous voltage will
cause death or severe personal injury. Follow all locally
approved safety procedures when working around high-
and low-voltage lines and equipment. G103.3
WARNING:
Before installing, operating, maintaining, or testing this
equipment, carefully read and understand the contents
of this manual. Improper operation, handling or
maintenance can result in death, severe personal injury,
and equipment damage. G101.0
WARNING:
This equipment is not intended to protect human life.
Follow all locally approved procedures and safety
practices when installing or operating this equipment.
Failure to comply can result in death, severe personal
injury and equipment damage. G102.1
WARNING:
Power distribution and transmission equipment must
be properly selected for the intended application. It
must be installed and serviced by competent personnel
who have been trained and understand proper safety
procedures. These instructions are written for such
personnel and are not a substitute for adequate
training and experience in safety procedures. Failure
to properly select, install or maintain power distribution
and transmission equipment can result in death, severe
personal injury, and equipment damage. G122.3
SAFETY FOR LIFE
Cooper Power Systems products meet or exceed all applicable industry standards relating to product safety. We actively
promote safe practices in the use and maintenance of our products through our service literature, instructional training
programs, and the continuous efforts of all Cooper Power Systems employees involved in product design, manufacture,
marketing and service.
We strongly urge that you always follow all locally approved safety procedures and safety instructions when working around
high-voltage lines and equipment and support our “Safety For Life” mission.
!
SAFETY
FOR LIFE
!
SAFETY
FOR LIFE
SAFETY INFORMATION
This manual may contain four types of hazard
statements:
DANGER:
Indicates a hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING:
Indicates a hazardous situation which, if not
avoided, could result In death or serious injury.
CAUTION:
Indicates a hazardous situation which, if not
avoided, could result in minor or moderate injury.
CAUTION: Indicates a hazardous situation
which, if not avoided, could result in
equipment damage only.
Hazard Statement Definitions
(12 paginas)
(110 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales