Cooper 9940 Guía de usuario descargar pdf (Pagina 20)

Appendix

Page 20 497282

Omitting Zones

Your system may be programmed so that you can omit individual detectors.

This enables you to ignore alarms coming from faulty detectors in non-critical

positions. Refer to the table on page 32 to see which zones can be omitted in

your system.

To omit a zone:

1. Key in an access code (or present a tag).

2. Press 2.

This display shows:

Omit Zone?

3. Press the number of the zone you want to

omit (for example, press 07 to omit zone

7) and then press y.

The sounder gives a double "beep" and

the display shows the zone number

followed by an "o":

Omit Zone 07o

If you try to omit a zone for which this is

not allowed, the display shows an "X"

after the zone number.

Omit Zone 07X

Press X to exit.

Note: To include a zone that was omitted, follow the same procedure.

Pressing y toggles between omit and include.

Normal Alarm Zones

When you next set the system, a message asks you to confirm that you want

to omit the zone. Press y to set the system with the zone omitted. Omission is

not permanent: when you next unset the system, the control unit reinstates

the zone. You must omit the zone each time you prepare to set the system.

24-hour Zones

When you next set the system, there is no message to confirm the omission.

24-hour zones (for example, protecting a fire door) remain omitted until you

reinstate them from the keypad:

1. Key in an access code (or present a tag).

Press 2 followed by the zone number and then y.

Press X to exit.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Sin comentarios

Cooper 9940 Guía de usuario Pagina 20